Product ID:ALUMNIGRIP LINEAR POLYURETHANE TOPCOAT COLORBASE
MSDS Date:01/29/1990
FSC:8010
NIIN:00F004241
MSDS Number: CDQRD

US PAINT CORPORATION (FORMERLY GROU GROUP INC)

831 S 21ST ST
ST LOUIS, MO 63103-3043
US

Emergency Phone: 314-621-0525/202-483-7616

Info Phone: 314-621-0525/202-483-7616

Cage: EO831

US PAINT CORPORATION

ST LOUIS, MO 63103-3092 US

Telephone: 314-621-0525

Cage: EO831

XYLENE, DIMETHYLBENZENE, XYLOL (IARC - GROUP 3) *96-4*

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 0-5%

OSHA PEL 100 PPM

ACGIH TLV: 100 PPM, SKIN

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

LEAD CHROMATE, LEAD CHROMIUM OXIDE (SUSPECTED HUMAN

CAS: 7758-97-6

RTECS: GB2975000

Fraction By Weight: 0-37%

OSHA PEL 0.1 MG/CUM (CRO3)

ACGIH TLV: 0.05 MG/CUM (PB)

CELLOSOLVE ACETATE (ETHYLENE GLYCOL ETHYL ETHER ACETATE),

CAS: 111-15-9

RTECS: KK8225000

Fraction By Weight: 14-27%

OSHA PEL 100 PPM

ACGIH TLV: 5 PPM SKIN

DIISOBUTYL KETONE

CAS: 108-83-8

RTECS: MJ5775000

Fraction By Weight: 1-4%

OSHA PEL 50 PPM

ACGIH TLV: 145 MG/CUM

PROPYLENEGLYCOL MONOMETHYL ETHER ACETATE,

CAS: 108-65-6

RTECS: AI8925000

Fraction By Weight: 5-27%

Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:EYES: CAN CAUSE SEVERE IRRITATION.
SKIN: CAN CAUSE MODERATE IRRITATION. INHALATION: CAN CAUSE
RESPIRATORY IRRITATION & ASPHYXIATION. INGESTION: HARMFUL, CAN
CAUSE BURNING SENSATION. CAN CAUSE IRRITATI ON TO MUCOUS MEMBRANES.
MAY CAUSE INJURY TO KIDNEYS, LIVER & LUNGS. HIGH VAPORS MAY CAUSE
CNS DEPRESSION. (SUPP)
Explanation of Carcinogenicity:SEE INGREDIENTS
Effects of Overexposure:IRRITATION, REDNESS, TEARING, BLURRED VISION,
DEFATTING, DERMATITIS, WEAKNESS, FATIGUE, NAUSEA, HEADACHE,
UNCONSCIOUSNESS, TIGHTNESS IN CHEST, BURNING SENSATION, SORE
THROAT, ABDOMINAL PAIN, VOMITING, DIARRHEA

First Aid:SKIN: WASH THOROUGHLY W/SOAP & WATER. EYES: FLUSH W/LARGE
AMOUNTS OF WATER. INGESTION: DON'T INDUCE VOMITING. INHALATION: IF
BREATHING IS DIFFICULT, REMOVE TO FRESH AIR. IF BREATHING HAS
STOPPED GIVE CPR. OBTAIN MEDICAL ATTENTION IN ALL CASES.

Flash Point Method:TCC
Flash Point:82F
Lower Limits:0.8
Extinguishing Media:DRY CHEMICAL/FOAM
Fire Fighting Procedures:SCBA W/FULL FACEPIECE OPERATED IN POSITIVE
PRESSURE MODE. TOXIC GASES & SMOKE ARE PRESENT.
Unusual Fire/Explosion Hazard:KEEP AWAY FROM HEAT, SPARKS & FLAME.
DON'T SMOKE. EXTINGUISH ALL SOURCES OF IGNITION INCLUDING
NON-EXPLOSION PROOF ELECTRICAL EQUIPMENT.

Spill Release Procedures:SMALL:ABSORB LIQUID ON INERT MATERIAL &
TRANSFER TO HOOD. LARGE:ELIMINATE IGNITION SOURCES. EVACUATE ALL
UNPROTECTED PERSONNEL. STOP AT SOURCE. CONTAIN TO PREVENT
SPREADING. PUMP LIQUID TO SALVAGE TAN K. ABSORB REMAINING LIQUID
W/INERT MATERIAL.(SUPP)

Handling and Storage Precautions:KEEP CONTAINER CLOSED TIGHT & UPRIGHT
TO PREVENT LEAKAGE. DON'T STORE ABOVE 120F. CONTAINERS RETAIN
PRODUCT RESIDUES OF VAPOR, LIQUID &/SOLID. (SUPP)
Other Precautions:PRODUCT MAY BE BLENDED W/OTHER PRODUCT W/OTHER
PRODUCTSPRIOR TO USE. READ ALL WARNINGS & PRECAUTIONS ON THE LABELS
OF ALL PRODUCTS BEING BLENDED AS THE COMBINATION MAY CONTAIN THE
HAZARDS OF EACH CONT AINER.

Respiratory Protection:WEAR APPROPRIATE PROPERLY FITTED NIOSH/MSHA
APPROVED RESPIRATOR DURING & AFTER APPLICATION UNLESS AIR
MONITORING DEMONSTRATES VAPORS, MIST & PARTICULATE LEVELS ARE BELOW
APPLICABLE LIMITS.
Ventilation:ADEQUATE VENTILATION. MAINTAIN CONTINUOUS FLOW OF FRESH
AIR. DON'T BREATHE VAPORS, SPRAY MISTS/SANDING DUST.
Protective Gloves:SOLVENT IMPERMEABLE
Eye Protection:SOLVENT RESISTANT W/SPLASH GUARDS
Other Protective Equipment:SOLVENT IMPERMEABLE GLOVES, CLOTHING & BOOTS
Work Hygienic Practices:DON'T GET IN EYES, ON SKIN/ON CLOTHING.
Supplemental Safety and Health
SPILLS: SHOVEL INTO CONTAINERS W/NON-SPARKING TOOLS. PREVENT RUN-OFF TO
SEWERS, STREAMS/OTHER BODIES OF WATER. HEALTH HAZ: INTENTIONAL
MISUSE BY DELIBERATELY CONCENTRATING & INHALING MAY BE HARMFUL/FA
TAL. OVEREXPOSURE MAY CAUSE BLOOD DISORDERS.

Boiling Pt:B.P. Text:178-343F
Vapor Density:>1
Evaporation Rate & Reference:SLOWER THAN ETHER
Percent Volatiles by Volume:50-60

Stability Indicator/Materials to Avoid:YES
OXIDIZING
MATERIALS,POTASSIUM-TERT-BUTOXIDE,PERMANGENATE,CHLOROFORM,CHLOROSUL
FONIC ACID,HYDROGEN PEROXIDE,NITRIC ACID
Stability Condition to Avoid:EXCESS HEAT
Hazardous Decomposition Products:CO, CO2 & OXIDES OF CARBON & NITROGEN

Waste Disposal Methods:ALLOW VOLATILE PORTION TO EVAPORATE IN HOOD
BEING SURE TO ALLOW FOR VAPORS TO COMPLETELY CLEAR HOOD DUCT WORK.
DISPOSE OF IAW/FEDERAL, STATE & LOCAL REGULATIONS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.